in NSX-T there's "bare-metal" option to choose for the edge's form.
the installation guide mentioned about the networking of bare-metal edge, as shown below:
the questions are:
1. if I want to use VLAN tagged traffic for the NIC eth0 as management network, should I configure the tag directly on eth0 or the internal device fp-eth0(e.g. vlan tag 1234 device: fp-eth0.1234)?
2. will the fp-eth0 be used for both management and overlay traffic? it's a little be confusing for me because each fp-ethx interface maps to a physical NIC therefore the fp-eth0 should be mapped to eth0.
3. the installation guide 2.2 said "up to four" of the internal interfaces can be allocated (depends on phy. NICs);
does that mean the maximum physical NIC for an edge is totally 4 (excluding the management NIC)?