Hello,
I have two DMZs with 2 external NSX ESGs in use. The Default Route DMZ logged fine after I setup the rules properly (which rules depend on routing methods, NAT, BGP, or OSPF). The 2nd one did not work as it was not within the domain of the default route. It had another route mechanism. In order for this one to work I had to setup a route within the VRLI instance itself. There are three ways to do this:
via CLI:
ip route add target/Prefix gateway
echo "target gateway netwask" > /etc/sysconfig/network/ifroute-eth0
via YAST
pretty easy to figure out, go to network, then route, then add
via VAMI
/opt/vmware/share/vami/vami_config_net
I would like to see this capability added to the Administration screens within the UI as well.
Thank you,
Edward L. Haletky