Hi all,
I am new to this forum and fairly new to vSphere in general. So, forgive me if the questions I am about to ask are easily found elsewhere on this site.
I spent most of my day Googling this but just ended up more confused in the end.
I currently have 3 ESXi hypervisors in my homelab in a vSphere cluster with HA, DRS, and vSAN enabled.
I am looking to setup a Windows test domain network. One VM, my gateway VM, will have two network adapters, one to connect it to the Internet, and the other to connect to the rest of the VMs in my test domain.
I cannot, for the life of me, figure out how to set this up.
In the past, when I had one ESXi box, I was able to do it by created a network with no uplinks attached to it. I cannot figure out how to set that up with distributed switches.
I have been told that the best way to replicate this would be to use VLANs. However, I am not too familiar with how to set those up and have been unsuccessful so far.
If anyone could point me in the right direction it would be much appreciated!