Hello Community Friends:
Looking for some advice / sign off. I am in the process of upgrading our vCenter 6.0, two host cluster to vCenter Appliance 6.5.
I think I have the basic steps down but I would like your input so I know that I am on the right track.
My Goal:
Upgrade existing vCenter Server 6.0 (Windows version to 6.5 VCSA (appliance version)
Add 2 new Dell PE R540 vSphere 6.5 hosts to the upgraded vCenter
vMotion all VMs from old hosts
Remove both of the old vSphere 6.0 Cisco UCS M4s servers from the cluster
Current cluster:
2 Cisco UCS M6 servers
vCenter 6.0 running on Windows Sever 2012
SAN: EMC VNXe3200
Storage protocol: FC
How the post cluster should look:
2 Dell Power Edge R540 servers
vCenter 6.5 (appliance)
SAN: EMC VNXe3200 - No changes here
Storage Protocol: FC - No changes here
Bellow are the steps I am taking to do the upgrade.
- Upgrade the existing vCenter 6.0 cluster to vCenter Appliance 6.5
- Install vSphere 6.5 on both new Dell R540 – This is complete
- Configure vSwitches – in progress
- Connect both new host to same storage (EMC VNXe3200) current vSphere 6.0 hosts– I did this already
- Configure Both of the new host to have access to the LUNs on the SAN – At this point the 2 new R540 vSphere 6.5 servers have access to the SAN and datastores as the Old Cisco UCS servers
- Provided that the upgrade to VCSA 6.5 was a success I can now add both of the new vSphere 6.5 servers to the cluster
- “Host Only” vMotion all VMs from the old 6.0 hosts to the new 6.5 host
- Remove the old 6.0 host from the new VCSA 6.5 cluster