Hello
I am running into an issue on my VMs. When I attempt to add an ISO file to the cdrom to the right is a 'connect' button. I tick this then save, I then start the VM in order to install my iso but it does not load and the VMware screen is looking for something to boot. I close it down and go back into settings and that 'connect' button is unticked.
I retick it and try again and sure enough its unticked again. So I cannot proceed.
I tried deleting the CD rom and adding again but the same problem persists, it does not matter which ISO I choose
Sorry if this is the wrong 'place' its not very clear where the right place is.